Professional Custom Lamp Holder Accessories Manufacturer

[2013-02-02]

Energy-saving lamps are single-ended fluorescent lamp holder(intubation lights) and self-ballasted fluorescent lamps (electronic lights) can be divided into two broad categories....

[2013-02-02]

How to choose the energy-saving lamps? (Such as the living room, bedroom, study, kitchen, bathroom, aisle) A: promulgated 10 years ago, "civil lighting design standards" GBJ133-90 has been low, now decorated residential illumination should improve a grade in order to achieve the effect of household satisfaction....

[2013-02-02]

Energy-saving lamp holders: the end connected to the energy-saving lamp cord for installation bulb interface, fixed the lights in parts of the lamp so that the lamp power supply connected to the lampholder. Electric light the lamp holder naming method. The main use of energy-saving lamps on a connector....

[2013-02-02]

B22 lamp holders: the lamp hoder is connected to the end of the lamp cord, interface for installing the lamp, fixed the lights in parts of the lamp so that the lamp power supply connected to the lampholder....

[2013-02-02]

1, the energy-saving lamps lampholders type sound light delay switch to set voice, copper-nickel lamp light control, the delay automatic control technology as a whole, by light control during the day when the light is strong, self-locking, the sound does not turn on the lights;...

[2013-02-02]

Lampholders: Is connected to the end of the lamp cord, bulb used for installation interface to be used with caution. Electric light the lamp holders naming method....

[2013-02-02]

LED lamp holder is transparent lampshade adopts imported polycarbonate injection molded, high strength, good transparency, LED is a light emitting diode (LED) as the light source of the light-emitting body....

[2013-02-02]

△ts finished lamp holders cap temperature rise measured in accordance with the QB / T 2512, its temperature rise during the start of the lights and the future stability and stable time should not exceed the following values​​:...

[2013-02-02]

Fixed parts of the insulation of the lamp holders and external electric shock insulation components, should be able to withstand the glow-wire test GB / T 5169.10 provides:...

[2013-02-02]

Self-ballasted electrodeless fluorescent lamp holders should have sufficient heat resistance. The insulating member of the external insulating member against electric shock of the lamp and the fixed charging member should have a sufficient heat resistance....