Professional Custom Lamp Holder Accessories Manufacturer

Remove the screws or submit connecting the lamp holder. There are actually typically two or 3 screws holding the fixture itself towards the bracket. Decrease the fixture down, exposing the wire connections. Once the fixture is down, use your hands or pliers to undo the wire nuts.

 

Wire nuts would be the plastic cone-looking pieces covering the ends of the place the wires come collectively, connecting the black and white wires coming from your fixture for the wires coming from your ceiling. There could possibly also be a ground wire from the fixture attached towards the metal of your junction box while in the ceiling by a screw.Connect the wires to the new fixture. The wires needs to be reattached from the exact same spots since the previous fixture, typically white to white, black to black, and ground (bare copper) to the metal junction box. Neutral wire-usually white-should be connected to neutral wire. Twist the wires two or three times with each other clockwise, or the same route you turn the wire nuts.

 

You may use both the old wire nuts or even the new ones supplied together with the fixture. To utilize the wire nut, location the stripped ends of each wire following to each and every other, with their points facing the identical path. Then area the wire nut over the ends and twist clockwise until the wires are secured inside the wire nut.

 

Use pliers to twist the ends on the wires together just before attempting to screw the wire nut on. That is primarily beneficial for houses with smaller sized gauge (thicker) wires.Do not be intimidated. With all the electricity off, the wires are harmless, and every thing is shade coded (black and white, or, outdoors the US, brown and black.).Often stick to the instructions (if any) supplied with the fixture.Usually utilize the new hardware (if any) offered together with the fixture.