Professional Custom Lamp Holder Accessories Manufacturer

As we all know, the installation of lamps and lanterns is not a knowledge, as long as the strength and understanding of the general tool can be used. In the installation of lamps and lanterns, if the control switch, you can save a lot of trouble. Because if only a total switch, a few lamp holder with cord, can not choose the light and shade, waste electricity, and installed on the control switch can at any time according to need to choose to open a few lights. If the door of the house is in the aisle, the end of the corridor is also equipped with a switch, so that the door will be able to turn off the power, and no need to go back to the door to turn off the lights lighting system should be set to adjust, that is, when the feeling of light or glare, can adjust the line, people will feel more comfortable, more comfortable. Light temperature should be consistent with the atmosphere of the room, at least to the other area of the bedroom's color temperature is similar.

 

In the top place of the installation of lamps and lanterns, reduce the shadow of the work not only in the central to install a separate lighting source, in order to improve the kitchen lighting, should be in the kitchen to install a different light source and light source composed of multi-level lighting system. Installation location is also very important. Linear incandescent or fluorescent lamps should be installed in the direction of the front part of the cabinet so that light emitted from the light is shot to the baffle, then reflected in the operating table, then fired the entire space if the space is high enough can in the ceiling installation transparent or translucent pendant lamp as the light source, chandeliers at this time not only can provide excellent lighting and good decorative items. Lamp installation, the most important is to be strong, you can pull the hand, feel.

The lamp cover should be close to the ceiling, can not shake. If chandelier, there will be a wire from the top to extend the lamp parts, should pay attention to, not from the wire is tight, should be loosely wrapped around the bar down, otherwise after the long-term taut wire problems easily. Careful inspection, can not have bare wires outside