Professional Custom Lamp Holder Accessories Manufacturer

A lot of people think that as long as the lamp is on, it means that there is no problem with the installation of lamps and lanterns. However, it is very important to install the lamps and lanterns, which is very important. If the installation is hasty, construction operations are not standardized, will give future life leave a security risk, will affect the lamp life that check James lighting installation how is installed after the try, if all the lights came on, did not ask questions when the installation of lighting and wiring should use insulation tape wrapped up, so that we can ensure lamps and lanterns to use is the sole criterion for safety lamp shines or not instead of checking fluorescent light fixture installation quality.

Actually, lighting fixture installation requirements first, strong, if not strong, lamps and lanterns is falling, safety accidents (1) lamp can not be installed with a wedge. Some of the construction electrician to facilitate easy, common wedge fixed lighting, there was no problem and very strong, but not reliable over time ② each lamp fixing screws or bolts not less than 2, when the insulation Taiwan diameter of 75 mm and below may be a screw or bolt ③ when the lamp is greater than the weight of three kilograms application when bolted, or fixed on the embedded hook, you can not install lamps with ceiling joists ④ stand only when the lamp weight at 500 grams and below is available to take advantage of flexible wire slings, greater than 500 g should be used for the hanging chain, and the flexible wire inserted in the hanging chain series, can not let the wire by force from the lamp boxes ① wire leads application software pipe protection to the lamp position to prevent the wires exposed within ② fixed flat top lamps live parts of insulating material providing protection against electric shock and insulating materials shall be resistant to burning and anti-fire, before the test can be used with a lighter look at the bathroom and kitchen equipment bantam ③ when the lamp, should adopt the porcelain bantam screw cap. light socket wiring, phase line (switches lines) should be grounded to the in the center of the contact terminals, zero line connected in screw terminals on the indoor installation wall lamp, lamp, table lamp, floor lamp, mirror lamp lamp height are often less than 2.4 meters.

At this time lamps and lanterns can be close to the bare conductor (such as metal shell, etc.) shall be according to ground or zero generally lamp installation is completed, ceiling or wall also need to use latex paint. To prevent emulsioni paint stained lamp, should the lamps and lanterns with textured paper or clinker a luminaire shall be protected.