Professional Custom Lamp Holder Accessories Manufacturer

Firstly,The load carrying capacity of the fixed part of the wall suspended ceiling lamp should be matched with the weight of the lamp, the lamp should be equipped with the hanging line box, and each of the hanging box can only be fitted with a set of pendant lamp. The surface of the pendant lamp must be well insulated, and there may not be a joint, and the wire cross section shall not be less than 0.4 mm. In the wiring box hanging line should be taken to prevent thrum stress the lamp drop measures. Weighed more than a kilogram of lamps should be arranged chain. When the chandelier lamp weight more than 3 kg, should use the embedded hook or a bolt fixed. Chain lamp lamp line should not be subjected to tensile, line lamp should be and chain series fork in 4 together, with incandescent lamp as the light source of ceiling lamp can not be installed directly on the flammable component; lighting shall be close to the lampshade; when lighting and insulation between the distance less than 5 mm, lighting and insulation of Taiwan should take measure to prevent the heat.The power of incandescent lamps shall be maximum power.

Secondly, which allows the use of the fluorescent lamp as light source, ballast should be installed in the line, the lamp should prevent the lamp foot off shell, and left margin in the lamp box internal decoration, ceiling lamps line frame and mega parallel, the lamp should be close to the border in the roof surface.

The screw cap line should be connected to terminal contact center, the zero line should be connected to the terminals of the insulating casing thread, the lamp holder should be complete, no damage and leakage.

AT Last,fixed lantern hook, its diameter should not be less than the minimum lamp hook, not less than 6 mm in diameter and 1 chandeliers, lamps the chandelier: installed on the top surface of the concrete, the embedded parts, bolt and bolt penetrating tube expansion. When installing the theme and the weight of the visible light to determine the tube expanding bolt specifications, but the minimum should not be less than M6 (mm), bull droplight should not be less than M8 (mm), the number of bolts at least less 2 pieces. Screw can be used 2, ceiling lamps, ceiling lamps have round, square or rectangular base (chassis), base sizes ranging from light tapping expansion of tubes. The base of the lamp can bolt expansion pipe, can also use wood screws in embedded block fastening. If the holder base diameter over 100 mm, must use the 2 screws. If the base of the lamp is installed, the bolt diameter shall not be less than 6 mm in diameter. Lamps and lanterns in Taiwan at the end of may be used for fixing the wood screw, wood screw number should not less than given by the lamp installation hole number 3, wall lamp, wall lamp according to the base structure can be the bottom or without base station. With the base station should be fixed base station, and then the lamp is fixed on the bottom table.

The end table is generally made of wood, and the thickness of the board should be more than 15 mm, and the surface of the paint is painted. Wall lamp installation can use light box installation screw hole into screw to fix the, also can be in the walls of the drilling, pre buried wood blocks or plastic expansion pipe screws to fix. Wall lamp base screw is generally less than 2 pieces. Wall lamp mounting height, lamps and lanterns center from the ground 2~2.2 meters, the installation of bedside wall lamp to 1.2-1.4 meters to 4, the lamp should be: downlight is recessed luminaires, applicable to the ceiling. Basic form of lamps and lanterns is cylindrical, mouth lamp for plating lead, titanium or nickel plated metal broadside ring, in the lamp installed later, close to the top surface, good decorative. The lamp tube has a symmetrical on both sides of the clamping spring device is fixed as downlight. The opening in the lamp opening direction, spacing adjustment nut spring by the butterfly.