Despite the fact that most aquarium tank lids are not overly high priced, it's even now a good concept to exchange the magnetic ballast when it stops functioning. In case the light flickers excessively when you flip the light on or even the light doesn't electrical power on in any way, it truly is time to replace the ballast. Basic family resources are required to change the ballast and also a quite essential understanding of electricity is required. Even so, altering the ballast will not be an overly tough procedure.
A).Remove the florescent light bulb through the aquarium bonnet by rotating it counterclockwise. There are two pins on each and every end of your light. Those pins line up with the grooves on the ballast brackets. With the pins lined up, pull the light out of the ballast brackets.
B).Take away the JAMES screws that secure the reflector plate to the inside with the aquarium bonnet then lift the reflector plate from the bonnet.
C).Eliminate the ballast brackets from the reflector location by pulling outward on them. They aren't bolted into place; they snap on. These brackets aren't reused simply because they are hard-wired towards the ballast. The new ballast is outfitted with new ballast brackets.
D)Clear away the wire nuts that cover the wire connections between the ballast plus the electrical switch. Create down which colour wire connects to each and every side of your switch. 1 wire is black and one particular wire is white. The brand new wires connect during the very same method.
E)Take out the bolts that safe the ballast towards the bonnet. Area the new ballast to the bonnet and safe it into area applying the old bolts.
F)Connect the white wire plus the black wire to the lamp holder and secure the wire nuts into spot.
G)Location the ballast brackets onto the ends from the reflector shield. Proceed to push inward on them until eventually they snap into area.
H)Place the reflector to the bonnet and safe it making use of the outdated bolts.
I)Location the pins located on each end on the florescent light into the grooves around the ballast brackets and turn the light clockwise to secure it into spot.
James supply the lamp holders, bulb holders, E27 lamp holder and GU10 lamp holder 30 years!
Copyright @2012-2016 James Lighting Ceramics & Electronic CO.,LTD